The B-Band UKKO-K kick drum contact mic system is a remarkable way to capture the true tonality of your
kick drum consistently, conveniently, and with extreme isolation. This system consists of two important components: the UKKO
DMK preamp, built with high-quality class-A electronics, and the UKKO DST1 Contact mic for superb tone. This system will work
with any size kick drum, and gives you high-resolution sound, and easy setup!
This mic system was designed to be able
to blend-in visually with the drum kit. That is why B-Band designed the DMK preamp to be chrome colored to match most drum
hardware. It is an extremely lightweight system that does not add any noticeable weight to the drum, or get in the way while
performing like most other drum mic systems. It also very robust and durable, and will endure rigorous touring.
up and tearing down have never been this easy. The DST1 has an adhesive back that mounts easily and discreetly on the inside
of the drum shell near the batter head. The DST1 lead wire is fed through the drum air hole to the DMK preamp. The preamp
mounts in the air hole outside of the drum, and was specially designed to not interrupt the flow of air as the drum breathes.
Being as the DMK preamp is so small in size, there is no need to remove it to put the drum in its case, leave it on and be
ready for the next gig or studio session.
To better capture the low frequencies of the kick drum there are two mini
switches inside the DMK preamp that contour the sound for a choice of tone. One switch controls a -6dB mid cut at 330 Hz and
the other is for a +6dB high boost at 5 kHz.
If you have a hole cut on your resonant head or if there is no resonant
head on your kick drum, this will make the UKKO-K sound thinner. It is recommended to have a solid resonant head for maximum
B-Band UKKO-K Single Kick Drum Contact Mic Features:
- Extreme isolation of each drum with no bleed from other drums
- Mounts without modification to the drum
- Reduces the need for audio gate effects
- Ultra-quick setups
- No need to position mics or mic stands; just plug a standard XLR cable into the preamp and play
- Clean looks without the clutter of mic stands
Save BIG when you buy today!
B-Band UKKO-K Single Kick Drum Contact Mic Specifications:
- Frequency response: 22Hz — 35kHz (-3dB)
- Phantom power required: 12 — 50-volt
- Output impedance: 200 ohm balanced
- Weight: 52 g.
- Dimensions: 76 mm (3.00") / 48mm (1.90") / 40mm (1.60")