High power rating and a big, clean sound.

The Eminence Commonwealth 15" Guitar Speaker delivers warm and rich tone, very clean and well defined. Great presence! Very full and smooth. Very little cone break-up, but likes overdrive.

Eminence Commonwealth 15 Guitar Speaker Features:

• Good for all genres
• Clean, warm, full, non-distorted, un-adulterated guitar tone

Put this replacement speaker in the cart and make your amp sound like new.

Eminence Commonwealth 15 Guitar Speaker Specifications:

• Specification
• Nominal Basket Diameter: 15", 381mm
• Nominal Impedance*: 4 ohms
• Power Rating**: 225W
• Resonance: 52Hz
• Usable Frequency Range: 50Hz-4kHz
• Sensitivity***: 100.8
• Magnet Weight: 109 oz.
• Gap Height: 0.29", 7.2mm
• Voice Coil Diameter: 4", 101.6mm
  
  Thiele & Small Parameters
• Resonant Frequency (fs): 52Hz
• DC Resistance (Re): 3.72
• Coil Inductance (Le): 0.22mH
• Mechanical Q (Qms): 6.75
• Electromagnetic Q (Qes): 0.57
• Total Q (Qts): 0.53
• Compliance Equivalent Volume (Vas): 163 liters / 5.8 cu. ft.
• Peak Diaphragm Displacement Volume (Vd): 29cc
• Mechanical Compliance of Suspension (Cms): 0.15mm/N
• BL Product (BL): 11.8 T-M
• Diaphragm Mass inc. Airload (Mms): 65 grams
• Efficiency Bandwidth Product (EBP): 91
• Maximum Linear Excursion (Xmax): 0.3mm
• Surface Area of Cone (Sd): 889.6 cm2
  
  Mounting Information
• Recommended Enclosure Volume:
• Sealed: Acceptable
• Vented: Acceptable
• Overall Diameter: 15.28", 388.0mm
• Baffle Hole Diameter: 14.06", 357.0mm
• Front Sealing Gasket: fitted as standard
• Rear Sealing Gasket:
• Mounting Holes Diameter: 0.26", 6.5mm
• Mounting Holes B.C.D.: 14.57", 370.0mm
• Depth: 6", 152mm
• Net Weight: 22.6 lbs., 10.3 kg
• Shipping Weight: 24.8 lbs., 11.3 kg
  
  Materials of Construction
• Aluminum voice coil
• Polyimide former
• Ferrite magnet
• Vented core
• Die-cast aluminum basket
• Paper Cone
• Cloth cone edge
• Aluminum dust cap
  
  *Please inquire about alternative impedances.
• **Multiple units exceed published rating evaluated under EIA 426A noise source and test standard while in a free-air, non-temperature controlled environment.
• ***The average output across the usable frequency range when applying 1W/1M into the nominal impedance. Ie: 2.83V/8ohms, 4V/16ohms.
• Eminence response curves are measured under the following conditions: All speakers are tested at 1w/1m using a variety of test set-ups for the appropriate impedance | LMS using 0.25" supplied microphone (software
• calibrated) mounted 1m from wall/baffle | 2ft. X 2ft. baffle is built into the wall with the speaker mounted flush against a steel ring for minimum diffraction | Hafler P1500 Trans-Nova amplifier | 2700 cu.ft. chamber with
• fiberglass on all six surfaces (three with custom-made wedges)