The Eminence Legend 1058 10" Guitar Speaker has a very meaty tone, but with sparkle, definition and a smooth top-end. This Eminence Legend speaker is great for blues, country and rock. High power, vintage, seamed cone tonality for guitar. It's an ideal Vintage alnico Jensen replacement speaker.

Eminence Legend 1058 10 Guitar Speaker Features:

• Voice Coil Diameter: 1.5", 38.1mm
• Magnet Weight: 16 oz.
• Power Rating.: 75W
• Sensitivity: 98.7

Put this Eminence speaker in the cart.

Eminence Legend 1058 10 Guitar Speaker Specifications:

• Nominal Basket Diameter: 10", 254mm
• Nominal Impedance: 8 ohms
• Power Rating*: 75W
• Resonance: 97Hz
• Usable Frequency Range: 100Hz-6kHz
• Sensitivity**: 98.7
• Magnet Weight: 16 oz.
  
  Thiele & Small Parameters
• Resonant Frequency (fs): 97Hz
• DC Resistance (Re): 7.49
• Coil Inductance (Le): 0.56mH
• Mechanical Q (Qms): 17.78
• Electromagnetic Q (Qes): 1.21
• Total Q (Qts): 1.13
• Compliance Equivalent Volume (Vas): 26.4 liters / 0.9 cu. ft.
• Peak Diaphragm Displacement Volume (Vd): 0cc
• Mechanical Compliance of Suspension (Cms): 0.16mm/N
• BL Product (BL): 8.0 T-M
• Diaphragm Mass inc. Airload (Mms): 17 grams
• Efficiency Bandwidth Product (EBP): 80
• Maximum Linear Excursion (Xmax): 0.0mm
• Surface Area of Cone (Sd): 344.9 cm2
  
  Mounting Information
• Recommended Enclosure Volume:
• Sealed: Acceptable
• Vented: Acceptable
• Overall Diameter: 10.11", 256.8mm
• Baffle Hole Diameter: 9.13", 231.8mm
• Front Sealing Gasket: fitted as standard
• Rear Sealing Gasket: fitted as standard
• Mounting Holes Diameter: 0.23", 5.7mm
• Mounting Holes B.C.D.: 9.6", 243.8mm
• Depth: 4.1", 104mm
• Net Weight: 4.4 lbs., 2 kg
• Shipping Weight: 5.4 lbs., 2.5 kg
  
  Materials of Construction
• Copper voice coil
• Polyimide former
• Ferrite magnet
• Non-vented core
• Pressed steel basket
• Paper Cone
• Paper cone edge
• Solid composition felt dust cap
  
  * Multiple units exceed published rating evaluated under EIA 426A noise source and test standard while in a free-air, non-temperature controlled environment.
• **The average output across the usable frequency range when applying 1W/1M into the nominal impedance. Ie: 2.83V/8ohms, 4V/16ohms.
• Eminence response curves are measured under the following conditions: All speakers are tested at 1w/1m using a variety of test set-ups for the appropriate impedance | LMS using 0.25" supplied microphone (software calibrated) mounted 1m from wall/baffle | 2ft. X 2ft. baffle is built into the wall with the speaker mounted flush against a steel ring for minimum diffraction | Hafler P1500 Trans-Nova amplifier | 2700 cu.ft. chamber with
• fiberglass on all six surfaces (three with custom-made wedges)