Joemeek's most advanced, full-featured channel strip with free JM37 condenser (while JM37 supplies last).

The OneQ is the most full-featured, technologically advanced studio channel Joemeek has ever made! The Joemeek OneQ is a single channel combining Mic Pre (with Burr-Brown IC), four band EQ, the most flexible yet, Joemeek's "signature" optical compressor, a De-Esser, and an Enhancer. It's a master channel like no other.

Housed in a 2u chassis, the elegantly sculpted faceplate is intelligently laid out, with clear, easy to read legends and a large analog VU meter. The OneQ also features 24-bit/96kHz A/D converters with word clock input and output.

Joemeek JM37 FET Condenser Mic: Not all mics and preamps play well together, and it's important to have a microphone whose response complements your preamp. That's why Joemeek includes the JM37 large diaphragm, FET condenser mic with the OneQ (while supplies last).

The JM37 is a high quality, large diaphragm condenser microphone with a fixed Cardioid pattern. Joemeek chose FET devices for both preamplifier and output stages, resulting in a mic that exhibits very pleasing audio qualities.

The capsule is manufactured in the classic "concentric electrode" design, providing smooth extended frequency response. We further enhanced the audio quality by using dynamic feedback at the capacitor element. This technique eliminates distortions, which can occur at high SPL.

The large 1.035" diaphragm is made from micro-fine Mylar and is gold sputtered. The microphone body is machined from brass, with audio connection via a balanced 3-pin XLR connector. Power is supplied via phantom power from either your console or microphone preamplifier.

You'll find that the JM37 is an excellent choice for male and female vocals, as well as acoustic guitar and other instruments.

Currently, the JM37 comes free with your purchase of the Joemeek OneQ channel strip, but only for as long as supplies last—so order your OneQ right away.

Put the OneQ's pure British tone at the front end of your DAW and you'll understand why they say, "The Meek shall inherit!" Order while supplies of the included free JM37 condenser mic last.

Joemeek OneQ Mono EQ/Compressor/Mic Pre Specifications:

• Input impedances: Mic: 1.2kohm; Line: 20kohm
• Pre-amp overall gain: 10dB to 60dB (variable)
• Common mode rejection: 70dB
• Equivalent input noise: 128.5dBu (unweighted)
• Distortion: 0.001% (below Compressor threshold)
• Frequency response: 15Hz to 70kHz (-3dB)
• Maximum input before clipping: Mic: +21dBu; Line: +45dBu
• Headroom before clipping: +21dBu
• Compressor threshold: infinity dBu to -20dBu (variable)
• Compressor ratio: 1:1 to 10:1 (variable)
• Compressor attack time: 1 msec to 100 msec (adaptive)
• Compressor release time: 0.1 sec to 3 sec (adaptive)
• Nominal output levels: +4dBu/-10dBv
• Output impedance: 100ohm
• Output Level switch: 12dB attenuation
• Noise Floor: 85dBu (typical, with ~40dB mic gain)
• VU Meter: Analogue movement
• Power supply: 115V / 230V ac mains, 50/60Hz
• Power consumption: 30W
• Mechanical: 482W x 88H x 220D (overall)
• Weight: 3 kilos
• High Pass Filter: 12dB per octave cut below 80Hz
• EQ Boost & Cut:+/-15dB (zero phase-shift bell response)
• LF Frequency: 80Hz/120Hz switchable
• LMF Frequency: 200Hz to 2kHz variable
• HMF Frequency: 1kHz to 6kHz variable
• HF Frequency: 7kHz/14kHz (selectable)
• EQ "Q": 0.9 (1.6 octaves)
  
  Digital Output Specifications
• Sampling: 24 Bit
• Sampling Rate: 44.1kHz, 48kHz, 88.2kHz or 96kHz selectable
• Output Formats: AES3 compliant (balanced), S/PDIF electrical, S/PDIF optical
• External Word Clock input: 75ohm, 1.25V - TTL level, 44.1kHz to 96kHz (auto synchronizing)
  
  JM37 FET Condenser Mic:
• Frequency response: Substantially flat 25Hz to 20KHz
• Sensitivity: 6mV/PA-40 +/-2dB (0dB= 1V/Pa 1000Hz)
• Recommended load impedance: 200 ohm
• Signal to noise ratio: 74dB
• Dynamic range: 126dB