Wah Control-Tilt the pedal back and forth.
Fuzz Control-Rotate the pedal left and right.
Bottom Panel:
Effects Order-Switches the order of the effects in the signal path to provide two distinct sounds. Experiment!
Fuzz Volume-Adjusts the volume level of the Fuzz effect so that you can match the volume level of your guitar when Fuzz is turned off. Also try setting it for a Fuzz effect volume boost!

Fender Classics Series Fuzz-Wah Pedal Specifications:

• Input Impedance: 1MOhm
• Nominal Input Level: 20dBV
• Output Impedance: Fuzz -> Wah = 1kOhm; Wah -> Fuzz = 50kOhm
• Nominal Output Level: 20dBV
• Power Requirements: 9VDC (center pin = negative); 10mA Minimum

Fender Classics Series Fuzz-Wah Pedal Features:

• Fuzz Switch-Turns the Fuzz effect on-off.
• Wah-Turns the Wah effect on-off.
• Input Jack-Plug your guitar (or other audio source) in here. Un-plug the input plug from this jack to turn off the device and save power (very important) when not in use.
• Output Jack-Connect to the input of your amplifier (or other audio device).
• 9V Battery-Open the battery compartment on the bottom of the unit by removing the thumb screw. Use alkaline batteries.
• DC Input Jack-Plug in a AC- 9V DC adaptor (Not Included, see specifications) into this jack to eliminate the need for batteries.

Wah-t the fuzz are you waiting for? Call or click today to order.