A studio microphone with a retro look, warm sound, and is optimized for vocal recordings with the
capsule of the legendary M 49 and U 47.
The Neumann TLM 49 is a large-diaphragm studio microphone with a cardioid directional characteristic
and a warm sound. The TLM 49 is specially optimized for vocal performance. It is supplied as a set, with an elastic suspension.
The
Neumann TLM 49's design is inspired by that of the legendary M 49 and M 50 microphones of the 1950s. Naturally the TLM 49
has the typical Neumann fine matte nickel finish. The sound design is also oriented toward that of the M 49 and the
U 47.
By combining its retro look with proven Neumann transformerless circuit technology, this microphone ensures
low self-noise and the use of high gain levels.
Applications
During the development phase, the sound was adjusted in extensive practical tests, so as to make the TLM 49 ideal particularly
for vocal and speech recording. However, in addition, it is also suitable for instrumental applications in professional production
studios and demanding home recordings.
Polar pattern
The large-diaphragm capsule of the TLM 49 provides a cardioid directional characteristic with a tendency toward supercardioid,
due to the special capsule construction. Following the example of the M 49, high frequencies are more directional. The capsule
diameter is 34 mm.
The front of the microphone is indicated by the red Neumann logo on the microphone body. The capsule
is oriented so that the microphone is addressed from the front.
Acoustic features
The TLM 49 uses the famous K 47 capsule, which was also used in the M 49 and the U 47. The capsule has a linear frequency
response up to the upper mid-range. Above 2 kHz there is a gentle presence boost up to 3dB.
The capsule is enclosed
by a large microphone head grille, which is acoustically very open and is hence neutral with regard to the sound.
Electrical
features
The letters TLM stand for "transformerless microphone". With TLM technology the usual output transformer is replaced by an
electronic circuit.
As with traditional transformers, it ensures good common mode rejection, and prevents RF interference
that may influence the balanced audio signal.
Noise signals which affect the balanced modulation line are therefore
effectively suppressed. The microphone can operate at sound pressure levels of up to 114 dB without distortion, and provides
a dynamic range of 102 dB (A-weighted).
Operational safety
The entire interior structure is mounted elastically, to prevent the transmission of structure-borne noise. In addition, the
capsule is mounted with a rubber shock mount.
Due to the wide frequency response, the TLM 49 can also transmit extremely
low-frequency signals without coloration. Of course this means that the microphone is also sensitive to noise signals such
as vibration noise and wind noise in this frequency range. The TLM 49 is therefore supplied with the elastic suspension EA
3, which effectively protects the microphone from structure-borne noise. If the microphone is addressed at extremely close
range, pop screen PS 15 or PS 20 a can be used in front of the microphone to provide protection against plosive sounds.
Requires
phantom power.
Neumann TLM 49 Condenser Studio Microphone Features:
- Sound profile optimized for vocal performance
- Pressure gradient transducer with the large-diaphragm capsule of the legendary U 47
- Cardiod characteristic
- Retro design
- Transformerless output circuitry
- Acoustically very open wire mesh headgrille
- Complete set with elastic suspension
Save BIG when you buy today!
Neumann TLM 49 Condenser Studio Microphone Specifications:
- Acoustical operating principle: Pressure gradient transducer
- Directional pattern: Cardioid
- Frequency range: 20 Hz ... 20 kHz
- Sensitivity at 1 kHz into 1 kohm: 13 mV/Pa
- Rated impedance: 50 ohms
- Rated load impedance: 1000 ohms
- Equivalent noise level, CCIR1): 23 dB
- Equivalent noise level, A-weighted1): 12 dB-A
- Signal-to-noise ratio, CCIR1) (rel. 94 dB SPL): 71 dB
- Signal-to-noise ratio, A-weighted1) (rel. 94 dB SPL): 82 dB
- Maximum SPL for THD < 0.5 %2): 110 dB
- Maximum SPL for THD < 5 %2) : 129 dB
- Maximum output voltage for THD < 5%: -1 dBu
- Dyn. range of the mic. amplifier /A-weighted, 0.5 %2)): 98 dB
- Dyn. range of the mic. amplifier /A-weighted, 5 %2)): 117 dB
- Supply voltage (P48, IEC 61938) : 48 V ± 4 V
- Current consumption (P48, IEC 61938): 3.2 mA
- Matching connector: XLR 3F
- Weight: 825 g
- Diameter: 78 mm
- Length: 165 mm
1) According to IEC 60268-1; CCIR-weighting according to CCIR 468-3, quasi peak; A-weighting according
to IEC 61672-1, RMS
- 2) Measured as equivalent el. input signal