|
|
|
|
|
The Ortofon Pro Concorde is a general purpose turntable cartridge for scratch and back cueing, mounted
with a spherical diamond. It achieves an output of 5.0 mV.
Several Ortofon technologies make it possible to realize
high sound quality and low record wear at the high tracking forces that are necessary in disco environments. DJs all over
the world claim very high demands to their professional DJ equipment, among which the cartridges plays their decisive part
by realizing that scratching, back-cueing, and live artistic performance are a big part of the show. Reliability and robustness
is vital, when these replacement cartridges night after night will have to withstand these demands in environments with extreme
sound pressure and vibration.
Scratching and back-cueing impose heavy mechanical stress on the cantilever and its rubber
bearing. Therefore, the Ortofon Pro Concorde cartridges are equipped with cantilevers made from aluminum tube with increased
wall thickness. Special attention has also been paid to the attachment of the bearing and the design of the bearing itself.
This means that rough treatment will neither damage the turntable cartridge nor degrade its stability.
For easier cueing,
the nose of all the Ortofon replacement cartridges have an extra large cut-out which makes the stylus freely visible from
above, and further, the tip of the cantilever is fluorescent.
Ortofon Pro Concorde Turntable Cartridge Twin Pack Features:
- 2 Pro Concorde turntable cartridges
Order this Ortofon cartridge pair and rock both your turntables the professional way.
Ortofon Pro Concorde Turntable Cartridge Twin Pack Specifications:
- Output voltage at 1000 Hz, 5cm/sec.: 5 mV
- Channel balance at 1 kHz: 2 dB
- Channel separation at 1 kHz: 20 dB
- Channel separation at 15 kHz: 15 dB
- Frequency range: 20-20.000 Hz
- Frequency response: 20-18.000 Hz + 3 / - 2 dB
- FIM distortion at recommended tracking force, DIN 45.542: < 1%
- Tracking ability at 315Hz at recommended tracking force: 70 µm
- Compliance, dynamic, lateral: 7µm/mN
- Stylus type: Spherical
- Stylus tip radius: R 18µm
- Equivalent stylus tip mass: 0,5 mg
- Tracking force range: 3,0-5,0 g (30-50 mN)
- Tracking force, recommended: 4,0 g (40 mN)
- Tracking angle: 20°
- Internal impedance, DC resistance: 750 Ohm
- Internal inductance: 450 mH
- Recommended load resistance: 47 kOhm
- Recommended load capacitance: 200-600 pF
- Cartridge colour, body/stylus: Silver/Silver
- Cartridge weight: 18,5 g
- Replacement stylus unit: PRO
|
|
|
|
|
|
|