Made to handle the highest trumpet SPLs and is always in position.
The AMT P800 Studio microphone system combines the most natural sounding trumpet specific microphone
system on the market with the AMT AP40 floor pre-amp. The AP40 converts the microphones to low impedance, it regulates the
voltage to each microphone, and with certain models creates a specific frequency curve. The curve is necessary on certain
models or instruments in order to maintain the most natural reproduction of sound in conjunction with achieving the most amount
of gain before feedback in a live application. The output of the preamp is an XLR Low Impedance balanced output. The output
sends signal at Mic Level.
The AMT P800 Studio Trumpet microphone system features an element somewhere in size between
a small and large diaphragm, which prevents even the loudest of trumpet players to not overload the microphone. AMT has developed
their special "Off the bell" clamping system for this model which clamps to the mouthpipe of the trumpet or flugelhorn.
The
AMT P800 microphone allows the player to easily change to and from AMT different preamps and allows for direct connections
to either Shure or Sennheiser beltpack transmitters. With a change in a cable, convert your P800 from a "Studio" style preamp,
to a "Belt pack" series model, or to the AMT "W"ireless setups. The microphone is suspended in a 4 point isolation ring reducing
key and handling noise. Phantom power or 9Volt battery required. Comes with AP40 floor or "DI" style preamp, hardshell case,
and AMT disconnecting cable technology to allow the microphone to be used as "Wireless" or "BP" models if needed. (Additional
cables for a variety of setups sold separately. The AMT Interface is also sold separately to allow connections for many wireless
systems.)
Applied Microphone Technology AMT P800 Studio Clip-On Trumpet Microphone System Features:
- Natural sounding trumpet specific microphone system
- Special element prevents microphone overload
- "Off the bell" clamping system
- Pre-amp regulates voltage to each microphone
- Converts microphones to low impedance
- Ground Lift switch
- Operates with Phantom power or 9-Volt battery
- Includes hardshell case and cables
- Converts from a "Studio" style preamp, to a "Belt pack" series model, or to the AMT "W"ireless setup
No trumpet sound is too piercing for this capable mic. Order today.
Applied Microphone Technology AMT P800 Studio Clip-On Trumpet Microphone System
Specifications:
- Element: Condenser
- Polar Pattern: Cardioid
- Frequency: 50Hz - 18kHz
- Sensitivity: 65dB+ 4dB
- Impedance: 150 Ohms
- Phantom Power: 12 to 52 vDC, Self-powered battery
- Max input SPL: 120 dB
- Dimension: 3.5" Flex Arm
- Cable: 6'
- Weight (Mic only): 36 grams