Modular 100W tube head with the Randall tone and voicing that you've been looking for.
The Randall RM100MM tube amp head is both traditional and modern technology rolled into one amplifier.
First, you have three independent modular channels that can be loaded with your choice and combination of the available tube
preamp modules. Load each channel with a preamp tone that fits only your needs with the ability to expand your arsenal anytime
a new tone is needed. Don't purchase an amplifier because you like just the clean or hi-gain tone. Build this Randall MTS
amp with your clean, your rhythm, and your hi-gain tone for a complete custom setup. With more than a dozen tube preamps always
available, chances are you'll have a hard time picking just three Randall MTS preamps.
Change and bias your own power tubes
Enjoy the ease of replacing your power tubes anytime you like with the Randall MTS RM100MM amp head's very user-friendly power
tube bias section, found on each MTS amplifier. If a tube fails, no problem, the Randall amp will kick that tube out of the
circuit and a small LED will light by the tube that fails. Simply replace the small protection fuse and tube using a small
voltage meter and screwdriver to adjust each individual bias point. If you like experimenting with different tube types, the
Randall MTS amp head's bias section allows you to pop-in and bias a new set of tubes in just a few minutes.
MIDI channel switching capability
Connect your Randall RM100MM amp head to any MIDI capable effects processor and program individual effects to each channel.
With the MIDI in/thru jacks simply select your channel and external effect using the included RF3 MIDI footswitch, press and
hold the channel switch button on the head for 2 seconds and hit the store button of the effects processor to save the preset.
The included footswitch will then select both the Randall RM100MM amp head's channel and effect you want at the same time.
Preamp Modules Included in the RM100MM Amp Head:
SL+: Based on the preamp circuit of a hot rodded Marshall® Super Lead. The classic Super Lead circuit adds more gain and
punch. Covers any classic Zeppelin to modern Zakk tone.
Plexi: Based on the preamp circuit of a classic Marshall®
Plexi. Anything from Page to Angus to Gibbons. The amp that defines the 70's rock and punk tone.
JTM: Based on the preamp circuit of a classic Marshall® JTM45. It's classic mid-gain tone with huge bottom end and smooth
Randall MTS Series RM100MM 100W Tube Guitar Amp Head Features:
- 3 Preamp Modules: SL+, Plexi,
- 100 Watts
- 6L6 Power tubes
- MIDI in/thru
- Master Volume, Presence, Density controls
- Parallel loop with front panel mix control
- Series loop
- Rear tube bias section
- Slave out
- 3-button MIDI footswitch included
- World voltage AC input selector (100/120/220/240)
Get the flexible tone you want with 3 Randall MTS preamp modules. Own this amp head today!