|
|
|
|
|
Good sound in a rugged disco cartridge.
The Ortofon Elecktro Concorde turntable cartridge was designed in close relationship with DJs. The rubber
suspension is especially developed for scratch and back cueing. It uses a spherical diamond and projects a high output (7.5
mV).
Several Ortofon technologies make it possible to get high sound quality and low record wear at the high tracking
forces that are necessary in disco environments. DJ's all over the world claim very high demands to their professional DJ
equipment, among which the Ortofon cartridges plays their decisive part by realizing that scratching, back-cueing, and live
artistic performance are a big part of the show. Reliability and robustness is vital, when the cartridges night after night
will have to withstand these demands in environments with extreme sound pressure and vibration.
Scratching and back-cueing
impose heavy mechanical stress on the cantilever and its rubber bearing. Therefore, the Ortofon cartridges are equipped with
cantilevers made from aluminum tube with increased wall thickness. Special attention has also been paid to the attachment
of the bearing and the design of the bearing itself. This means that rough treatment will neither damage these replacement
cartridges nor degrade their stability.
For easier cueing, the nose of all the Ortofon cartridges have an extra large
cut-out which makes the stylus freely visible from above, and further, the tip of the cantilever is fluorescent.
Ortofon Elecktro Concorde Twin Pack Turntable Cartridge Features:
- 2 Ortofon Electro Concorde turntable cartridges
Order this pair of Ortofon cartridges today and rock both your turntables.
Ortofon Elecktro Concorde Twin Pack Turntable Cartridge Specifications:
- Output voltage at 1000 Hz, 5cm/sec.: 7,5 mV
- Channel balance at 1 kHz: 1,5 dB
- Channel separation at 1 kHz: 25 dB
- Channel separation at 15 kHz: 15 dB
- Frequency range: 20-22.000 Hz
- Frequency response: 20-15.000 Hz +3 / -2 dB
- FIM distortion at recommended tracking force, DIN 45.542: < 1%
- Tracking ability at 315Hz at recommended tracking force: 80µm
- Compliance, dynamic, lateral: 6µm/mN
- Stylus type: Spherical
- Stylus tip radius: R 18µm
- Equivalent stylus tip mass: 0,6 mg
- Tracking force range: 3,0-5,0 g (30-50 mN)
- Tracking force, recommended: 4,0 g (40 mN)
- Tracking angle: 20°
- Internal impedance, DC resistance: 750 Ohm
- Internal inductance: 450 mH
- Recommended load resistance: 47 kOhm
- Recommended load capacitance: 200-600 pF
- Cartridge colour, body/stylus: White/White
- Cartridge weight: 18,5 g
- Replacement stylus unit: Elektro
|
|
|
|
|
|
|